Option 1: 2Nm
1 x 57HSE76 2Nm close loop stepper motor (8mm shaft)
1 x HBS57H driver
1 x 3 meters encoder cable
Option 2: 2.5Nm
1 x 57HSE100 2.5Nm close loop stepper motor (8mm shaft)
1 x HBS57H driver
1 x 3 meters encoder cable
Option 3: 3Nm
1 x 57HSE112 2.5Nm close loop stepper motor (8mm shaft)
1 x HBS57H driver
1 x 3 meters encoder cable
1. High-quality chips and capacitor modules |
2. Use twisted pair shielded wire |
3. Low temperature and low noise |
current:3A |
Speed :0-1000rpm |
motor shaft : 8mm |
Input Phase : 2phase |
Torque :2N.m/2.5N.m/3N.m |
|
Motor temperature resistance:≤85° |
Model: HBS57 |
Drive section |
Input voltage |
DC20-50V, typical use 36V or 48V |
Control signal input current |
7.0-16mA |
Step pulse frequency |
1-200K |
Speed range |
The stepper motor in our shop can reach 1500rpm without load. It is recommended to use the host computer to adjust the speed at 0-600rpm during use. |
Subdivision settings |
16 gears are optional, up to 40,000 subdivisions. DIP setting |
Dimensions/Weight |
118.5*85*35mm, 190g |
Wiring |
Wiring type, the driver comes with terminals, it is recommended touse loose wires to connect |
Name |
Instruction |
PUL+ |
Pulse input signal: The valid edge of the pulse is adjustable, and the default pulse rising edge is valid; in order to respond to the pulse signal reliably, the pulse width should be greater than 1.2μs. 5~24VDC level compatible. In double pulse mode: CW |
PUL- |
|
DIR+ |
Direction input signal: high/low level signal, in order to ensure the reliable commutation of the motor, the direction signal should be established at least 5μs before the pulse signal. 5~24VDC level compatible. In double pulse mode: CCW |
DIR- |
|
ENA+ |
Enable control signal, this input signal is used to enable or disable the driver output. When ENA is connected to low level (or the internal optocoupler is turned on), the driver will cut off the current of each phase of the motor so that the motor is in a free state and does not respond to input signal pulses. When this function is not needed, the enable signal terminal can be left floating. 5~24VDC level compatible. |
ENA- |
|
PEND+ |
Enable control signal, this input signal is used to enable or disable the driver output. When ENA is connected to low level (or the internal optocoupler is turned on), the driver will cut off the current of each phase of the motor so that the motor is in a free state and does not respond to input signal pulses. When this function is not needed, the enable signal terminal can be left floating. 5~24VDC level compatible. |
PEND- |
|
ALM+ |
Fault signal output, in the form of open collector, must use pull-up resistors 5V12V24V and 0.5K1K2K resistors respectively, the fault output logic can be set by PC software |
ALM- |